The Lift Thin Multi Wire Cutting Machine page contains a dense archived specification set. It pairs thin-wire slicing claims with the machine envelope, cutting space, installed power and motion ranges.
- Wire and slab range
- Wire diameter is 0.45–0.65mm, while listed slab thickness is 5–30mm.
- Cutting space
- Cutting length is 3700mm; cutting height and cutting width are each 2200mm.
- Machine envelope
- Length is 11000mm, width 7000mm and maximum height 6500mm.
- Power and motion
- Total installed power is 300kW, linear speed 35m/s and rising speed 0–420mm/min.
Archived production claims
The page states a material yield above 97%, efficiency 1.5–2 times conventional cutting and stone-waste reduction above 80%. It also says the machine can cut hard stone with no vibration and low noise. No reference machine, stone, wire set or test record is attached, so these remain supplier claims.
Main-motor and block references
The main-motor entry is 64KWx4=256kW, and the listed block dimension is 3500x2200mm. The source does not explain installation clearances or utilities.
Selection boundary
The specification values should be confirmed against the current offered machine before layout or production planning. The video introduces the thin-multiwire system; it does not replace a signed configuration and site drawing.
Original case images
