This operation video is titled around horizontal cutting with a Huada stone wire saw. The archived note also lists vertical and inclined cutting, establishing machine orientation range without giving a site, stone or completed result.
Horizontal plane as the primary subject
A horizontal wire-saw cut can define the lower face of a quarry block or divide material in another planned operation. Machine position, wire entry and guide-pulley anchors must follow the actual geometry. The title does not preserve the pulley route shown in the recording.
Other orientations need new setup
Vertical and oblique cutting are named as additional capabilities. Changing the plane changes machine placement, guides, block support and wire contact. It should not be described as a simple control selection without a new layout and risk check.
What the operation record should contain
Identify the stone, machine, wire and intended plane before cutting. Photograph the marked face and guide positions, then record cut area, time, surface and wire condition only from measured work.
The saved video URL is also used by another performance-themed article in this archive. This page remains focused on cutting orientation; it does not create separate drive-performance evidence from the same recording.
